18151
General Mach Discussion / Re: Front & rear toolpost in Turn 42.020
« on: August 27, 2009, 08:50:21 AM »
If you only have either a front or a rear post and not both then there is no need to do the scale factor.
Your problem is two fold, firstly it is G51 not G52 and the main reason you will be needing to use it is I think you must have the setting for "Show tool above centreline in Turn" chosen. For a front post lathe you dont want that. You will get it from Config menu then down to ToolPath.
If you still have problems attach your xml and I will have a look.
Hood
Your problem is two fold, firstly it is G51 not G52 and the main reason you will be needing to use it is I think you must have the setting for "Show tool above centreline in Turn" chosen. For a front post lathe you dont want that. You will get it from Config menu then down to ToolPath.
If you still have problems attach your xml and I will have a look.
Hood