12851
General Mach Discussion / Re: Mach3Turn Offsets?
« on: February 06, 2011, 10:46:18 AM »
Looks like its working well, bit of vibration due to amount sticking out the chuck on the first part but looks like the surface finish is fine so no probs
Regards the pecking, your PP is set up I think to have it as a canned cycle, that is broken in Turn so wont rapid back in, I altered my PP to make Dolphin calc in long hand rather than canned, load this and see if its better for you, the options in Dolphin should now work for drilling cycles and the code should be long hand rather than canned.
Hood
Regards the pecking, your PP is set up I think to have it as a canned cycle, that is broken in Turn so wont rapid back in, I altered my PP to make Dolphin calc in long hand rather than canned, load this and see if its better for you, the options in Dolphin should now work for drilling cycles and the code should be long hand rather than canned.
Hood