11681
General Mach Discussion / Re: z home switch for toolchanger
« on: May 18, 2011, 06:21:21 PM »
the xml is the file that holds all your configuration settings. If you attach it I can load it and maybe see where your problem is.
The name of the xml will be the same as the profile you use so open Mach and look at the profile name (lower right of main page) then look in the Mach 3 folder for a file with that name and a xml extension.
Hood
The name of the xml will be the same as the profile you use so open Mach and look at the profile name (lower right of main page) then look in the Mach 3 folder for a file with that name and a xml extension.
Hood