2541
General Mach Discussion / Re: Mach3Turn gcode from CAD profile?
« on: June 24, 2014, 02:13:10 PM »
You would need CAM for that.
There is LazyTurn from Mach but I dont think it was ever really finished and I do not know how good it is.
There are a few reasonably priced CAM packages available for Lathes, the two I have used are Dolphin and BobCAD, of the two I prefer BobCAD but Dolphin does a good job.
Hood
There is LazyTurn from Mach but I dont think it was ever really finished and I do not know how good it is.
There are a few reasonably priced CAM packages available for Lathes, the two I have used are Dolphin and BobCAD, of the two I prefer BobCAD but Dolphin does a good job.
Hood