18811
General Mach Discussion / Re: Limitations of PC Parrallel Port
« on: June 19, 2009, 06:47:19 AM »
Another reason that fast accell is probably better is because if you had slow accell you may be bothered with corner rounding whilst in Constant Velocity mode. If that was the case then you would be using Exact Stop which would put more strain on the hardware.
Its probably not really worth bothering about but I would certainly prefer to compromise my rapids to get faster accell rather than the other way around, even if its just from a machining point of view, and you will probably find the faster accell/slower rapids would make the cycle time faster than the other way around.
Hood
Its probably not really worth bothering about but I would certainly prefer to compromise my rapids to get faster accell rather than the other way around, even if its just from a machining point of view, and you will probably find the faster accell/slower rapids would make the cycle time faster than the other way around.
Hood