4391
General Mach Discussion / Re: How to manually set Current Position, Machine Coord, and Work Offset to zero.
« on: August 19, 2013, 05:49:10 AM »
Ok just looked, MaxCL states pin 12 is for Home and Limit switches, ie it would seem it is the input you would use for ALL axes.
I would say that means RefAll will not act correctly for you as you are not wanting X or Y to move.
As a test can you disable the Z limit input and see if it helps, Z of course will not move but it will possibly make X and Y work as you want, expect and how Mach normally works.
Let me know what happens when you do that, please, and we can then go from there.
Hood
I would say that means RefAll will not act correctly for you as you are not wanting X or Y to move.
As a test can you disable the Z limit input and see if it helps, Z of course will not move but it will possibly make X and Y work as you want, expect and how Mach normally works.
Let me know what happens when you do that, please, and we can then go from there.
Hood