19321
General Mach Discussion / Re: Z axis 0
« on: May 03, 2009, 09:27:35 AM »
Seems to be working fine here in simulation, the Z DRO shows the correct cutting depth.
What I did was Home then jogged to a point away from home on all axis then pressed zero on all. I then pressed start, the Z went up to 0.75 then X and Y moved to the start, Z went down and all seemed fine.
If that is not what you are doing can you please explain as best you can and I will try and replicate.
BTW you have jog control switched off so you will need to enable that before you can jog.
Hood
What I did was Home then jogged to a point away from home on all axis then pressed zero on all. I then pressed start, the Z went up to 0.75 then X and Y moved to the start, Z went down and all seemed fine.
If that is not what you are doing can you please explain as best you can and I will try and replicate.
BTW you have jog control switched off so you will need to enable that before you can jog.
Hood