23171
General Mach Discussion / Re: Limit/Homin switches
« on: May 16, 2008, 10:30:52 AM »
If you either type G28 into the MDI line and press Enter or have it at the start of your code the machine will go to that position.
Alternatively you could go to the Operator menu then down to Edit VB Buttons and then the Ref All button should be flashing, click on it and in the Editor that pops up put the following on the last line and save it.
Code "G28"
Next time you press the Ref All your machine should ref all axis and then move to the G28 position.
Hood
Alternatively you could go to the Operator menu then down to Edit VB Buttons and then the Ref All button should be flashing, click on it and in the Editor that pops up put the following on the last line and save it.
Code "G28"
Next time you press the Ref All your machine should ref all axis and then move to the G28 position.
Hood