11721
General Mach Discussion / Re: Axis Stops Working
« on: May 13, 2011, 04:00:08 AM »
From your description the axis is stalling.
Have you tried Sherline mode?
Have you checked the voltage being supplied to your drives when axis are moving?
Can you swap X and Y drives around to see if the issue follows the drive?
Is the line in the driver test flat or does it have spikes?
Hood
Have you tried Sherline mode?
Have you checked the voltage being supplied to your drives when axis are moving?
Can you swap X and Y drives around to see if the issue follows the drive?
Is the line in the driver test flat or does it have spikes?
Hood