18121
General Mach Discussion / Re: LATHE TOOL TABLE
« on: August 29, 2009, 12:46:24 PM »
Have you restarted Mach since you put the licence in the folder? If it was placed in after you first start Mach then it will show demo until you restart Mach
Is it the Mach1Lic.dat that you have in there and is it definitely in the root folder?
As said above the Tool Offset Table does show 253 tool offsets but afraid you ccan only use 99 because of the Industry standard way of calling tools on a Lathe which Mach follows.
Hood
Is it the Mach1Lic.dat that you have in there and is it definitely in the root folder?
As said above the Tool Offset Table does show 253 tool offsets but afraid you ccan only use 99 because of the Industry standard way of calling tools on a Lathe which Mach follows.
Hood