12771
General Mach Discussion / Re: Problems with axis accuracy - MachTurn
« on: February 14, 2011, 03:30:44 PM »
My lathe will repeat as close as I can reasonably measure, would say less than 0.005mm
My lathe however has ground high precision ballscrews with virtually no backlash, has a resolution of 0.000625mm fromr AC servos and weighs 3 tonne so its really not a good one to compare yours to.
Hood
My lathe however has ground high precision ballscrews with virtually no backlash, has a resolution of 0.000625mm fromr AC servos and weighs 3 tonne so its really not a good one to compare yours to.
Hood