21941
General Mach Discussion / Re: Want to run multiple toolpaths in succession
« on: August 30, 2008, 07:38:22 PM »
Just copy each of your programmes in turn into a blank notepad file, take out the M30 in between these programmes and add a G52 Y* (or X* if stacking lengthways)
What that will do is move your Y axis (or X) by the amount you have entered (where I have put the *)
Its easier to do than explain, do a bit of messing around with the G52 and you will soon see how it works.
Hood
What that will do is move your Y axis (or X) by the amount you have entered (where I have put the *)
Its easier to do than explain, do a bit of messing around with the G52 and you will soon see how it works.
Hood