9071
General Mach Discussion / Re: Calibrating (tuning) twin axis
« on: March 26, 2012, 12:15:17 PM »
I would reduce both for testing and if it helps then wind them up one at a time.
To me acceleration is more important than velocity, if you have to wind down the velocity to get a slightly better acceleration it will usually pay dividends. My experience however is rigid metal cutting machines so that may not be the case for everyone.
Hood
To me acceleration is more important than velocity, if you have to wind down the velocity to get a slightly better acceleration it will usually pay dividends. My experience however is rigid metal cutting machines so that may not be the case for everyone.
Hood