3821
Show"N"Tell ( Your Machines) / Re: Where do I start Bridgeport Interact Series 1
« on: November 17, 2013, 02:54:59 PM »
Yes it will work, its lower count than I would like but will still be fine. I would put that one on the Z.
It is also single ended so personally I would make up a line driver to make it differential, you can also buy the line drivers, think www.cncdrives.com sell line drivers ready made fairly cheap.
Do the colours check out, well Red Black and Green anyway as without a scope you wont really know the others. However if they are correct then its likely the others are.
Hood
It is also single ended so personally I would make up a line driver to make it differential, you can also buy the line drivers, think www.cncdrives.com sell line drivers ready made fairly cheap.
Do the colours check out, well Red Black and Green anyway as without a scope you wont really know the others. However if they are correct then its likely the others are.
Hood