7401
General Mach Discussion / Re: MDI Input
« on: September 24, 2012, 04:17:41 PM »
You have your steps per unit set incorrectly in motor tuning.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Quotethey were gleaming
Send me a picture..................... haven't seen that in ages.
Brett
They are AC.Cont current only worked out about 32Amps and Peak actually was 293A, either that or my calcs are wrong.
Serious beasts indeed at 220Amps... Sounds more like a TIG welding machine spec than a servo's Continuous current was probably around 70Amps and hence the power in access of 6kW... WOW! Probably were high RPM and low torque.
Dan