4401
General Mach Discussion / Re: 3020T estop not stopping the spindle
« on: August 18, 2013, 04:34:04 AM »
E-Stop should not rely on software to stop axes/spindle etc. It often is set up that way however, especially on home builds and cheap machines but it should be considered dangerous relying solely on software for such E-Stop situations.
Having said that Mach should stop everything that it has control over when E-Stop is pressed, if the spindle is not stopping then either Mach does not control it or there is a config issue.
Attach your xml and also if possible some documentation to the machines setup (components) and maybe the issue can be found.
Hood
Having said that Mach should stop everything that it has control over when E-Stop is pressed, if the spindle is not stopping then either Mach does not control it or there is a config issue.
Attach your xml and also if possible some documentation to the machines setup (components) and maybe the issue can be found.
Hood