15291
General Mach Discussion / Re: Can I convert to Mach 3
« on: July 20, 2010, 09:52:49 AM »
Not looked at your pics properly yet, they are a bit big
Having said that what you want is your meter on its lowest resistance setting and you are looking for 0 resistance when testing between pin on port and a wire.
Problem you will have is that it goes through a load of electronics on that breakout board so you are not going to be very successful at it
I will see if I can look at the pics closely and I may be able to work out where the traces go, but will probably be later today as I have a fair bit of work to get on with.
Hood
Having said that what you want is your meter on its lowest resistance setting and you are looking for 0 resistance when testing between pin on port and a wire.
Problem you will have is that it goes through a load of electronics on that breakout board so you are not going to be very successful at it
I will see if I can look at the pics closely and I may be able to work out where the traces go, but will probably be later today as I have a fair bit of work to get on with.
Hood