20721
General Mach Discussion / Re: Error messages
« on: December 29, 2008, 02:01:20 PM »
Deboounce is basically the length of time Mach will see a signal before it acts on it. If you have switches that physically bounce or have noise in the wiring of these switches Mach will see it as a switch being triggered, by setting the debounce higher you are telling Mach to wait for a longer period of signal before it acts on it, that way your short burts are not acted upon by Mach and only a true activation of the switch will be seen. Ideally you want the debounce set to zero and to achieve that you need to have properly shielded wires from the switches, avoid routing the wires near others that carry higher voltages and if its physical bounce then you need better quality switches.
Your pulley issue could be that you have the spindle relays enabled and as such Mach thinks its in control of the spindle so looks at the pulley speeds and gives you the error.
Hood
Your pulley issue could be that you have the spindle relays enabled and as such Mach thinks its in control of the spindle so looks at the pulley speeds and gives you the error.
Hood