23591
General Mach Discussion / Re: Can someone review my code adn explain M01
« on: March 04, 2008, 02:17:47 AM »I did not think I had to learn g-code because I thought the cam did it all but I looks like there is alot of g-code tweeking that needs to be done. Can anyone point me to a good tutorial?
It is always good to know Gcode but I must admit I am fairly poor on it, however you CAM package should almost always put out code that you dont have to tweak. Your problem is in settings, some in CAM and some in Mach. For example if you have a look in the General config page of Mach you will see an opttion to stop on M1 command, you could take the check out of that box if you wanted. Most of the rest are in SolidCAMs options, you can define start heights, safe distances etc there.
Hood