18111
General Mach Discussion / Re: Permanent Offset Error
« on: August 30, 2009, 06:48:48 AM »
You have your motors tuned too fast for your kernel, try increasing the kernel to 45KHz or detune your velocity.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
It was facemilling, and mid face milling the z axis hopped up from -.125" to 1.95" (?) when in the code there was NO z axis instructions.
Then, when i want it to cut a circle around the part im making it won't and i just get a "zero radius arcline 38" in the status bar.