12011
General Mach Discussion / Re: Offsets and saving.
« on: March 28, 2011, 04:33:38 AM »
Tweakie
Think the tool table offsets will still be saved, AFAIK these are for DROs.
jtcdudeman
Do yo use a toolholder system where you can set up tools all at once then run a programme or do you have to set each one up each time you put it into the spindle. If the latter then no need for tool table entries. If the former then the only way I think you could do it is have a macro that is called at startup to zero the DROs, let me know which and if the former I may be able to assist with the macro although I am not great at VB.
Hood
Think the tool table offsets will still be saved, AFAIK these are for DROs.
jtcdudeman
Do yo use a toolholder system where you can set up tools all at once then run a programme or do you have to set each one up each time you put it into the spindle. If the latter then no need for tool table entries. If the former then the only way I think you could do it is have a macro that is called at startup to zero the DROs, let me know which and if the former I may be able to assist with the macro although I am not great at VB.
Hood