24141
General Mach Discussion / Re: Homing direction problem
« on: December 08, 2007, 02:08:02 PM »
Check/uncheck the Home Neg option.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Brian, if after feedhold, you jog the table, what would the procedure be to continue from where you had hit the feedhold?When you press Start you should then get a prep move box popping up showing the move it will make to get back to where it left off. If this is correct you press OK and it will make that move and wait for you to press the start again to continue with the code.