23741
General Mach Discussion / Re: Zero X & Y axis based on laser cross
« on: February 09, 2008, 02:16:44 PM »
Oh well that was easier than I thought, well that is if its what you are wanting.
What you need to do is add a button to your Mach screen, then make sure you set it as a VB button. Save your screen and then load Mach, go to the Operator menu and choose to Edit button script. Your new button should be flashing and all you do is click on it then paste the following into it and save.
Call setOEMDro (800,-49)
Call setOEMDro (801,-129)
Obviously you will have to put the numbers in that your laser is away from the actual spindle center but you get the idea.
If I am again misunderstanding just shout and I will kick myself
Hood
What you need to do is add a button to your Mach screen, then make sure you set it as a VB button. Save your screen and then load Mach, go to the Operator menu and choose to Edit button script. Your new button should be flashing and all you do is click on it then paste the following into it and save.
Call setOEMDro (800,-49)
Call setOEMDro (801,-129)
Obviously you will have to put the numbers in that your laser is away from the actual spindle center but you get the idea.
If I am again misunderstanding just shout and I will kick myself
Hood