16161
General Mach Discussion / Re: tool changes
« on: March 16, 2010, 11:56:42 AM »
M is spindle stop, it has nothing to do with a tool change, well obviously the spindle needs to stop for a toolchange but....
What you need for a toolchange is M6 and T* where * is the tool number.
If your code has that then look at General Config page and for ToolChange choose the stop spindle and wait for start option
Hood
What you need for a toolchange is M6 and T* where * is the tool number.
If your code has that then look at General Config page and for ToolChange choose the stop spindle and wait for start option
Hood