18341
General Mach Discussion / Re: very strange problem
« on: August 11, 2009, 05:35:34 AM »
If the xml you sent me is the one you are using then you have the native units set to inches.
What is the pitch of your ballscrews?
What microstepping do you have the drives set to?
What is the gearing between motor and screw?
If indeed your steps per mm are 2000 then your kernel speed will need to be increased when you change the native units to mm rather than inches as with your present setting of 25KHz your max rapid would be 750mm/min
Hood
What is the pitch of your ballscrews?
What microstepping do you have the drives set to?
What is the gearing between motor and screw?
If indeed your steps per mm are 2000 then your kernel speed will need to be increased when you change the native units to mm rather than inches as with your present setting of 25KHz your max rapid would be 750mm/min
Hood