771
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: May 23, 2016, 05:05:19 PM »
Connecting will be no problem as long as you have a computer with a serial port or if not a USB to serial adapter.
Just connect pin 5 on drive to pin 5 on DB9 connector and then pin 2 on drive to 3 on DB9 and 3 on drive to 2 on DB9.
Don't suppose you have a link to the software as well?
Usually much easier to set things up on a laptop rather than use the front panel but it depends how user friendly the software it. The Allen Bradley software (UltraWare) is quite nice but the software for the drives I have on the Chiron is a bit less so, still easier than front panel though
Did you get the drive/motor from that link you attached? seems very quick delivery if from China.
Hood
Just connect pin 5 on drive to pin 5 on DB9 connector and then pin 2 on drive to 3 on DB9 and 3 on drive to 2 on DB9.
Don't suppose you have a link to the software as well?
Usually much easier to set things up on a laptop rather than use the front panel but it depends how user friendly the software it. The Allen Bradley software (UltraWare) is quite nice but the software for the drives I have on the Chiron is a bit less so, still easier than front panel though
Did you get the drive/motor from that link you attached? seems very quick delivery if from China.
Hood