23451
General Mach Discussion / Re: How to wire steppers???
« on: April 03, 2008, 04:42:49 AM »
Jim putting them parallel will give you more torque but I would think lower speed.
Just out of interest are you using the Chinese drives that Arc Euro and others sell?
I have just built a small coil winder for a customer and I am having some issues, not sure exactly where the problem is lying yet but I am starting to think harware side of things.
Hood
Just out of interest are you using the Chinese drives that Arc Euro and others sell?
I have just built a small coil winder for a customer and I am having some issues, not sure exactly where the problem is lying yet but I am starting to think harware side of things.
Hood