12671
General Mach Discussion / Re: Closed loop options?
« on: February 18, 2011, 04:39:35 AM »
Have attached the code for the PCB I made, it says .5mm dia cutter but I actually used a 60 degree engraving cutter in the end.
Have also attached an iges of the board, just have to make sure you make it the right way round
Presume thats H-4050 motors? They should work 1:1 but you may need to get some active shunts for the drives. I think the 009 drives are micro drives so no shunt circuitry in them. I have 020 drives and I still needed the active shunts to get the best accel I could, see pic.
Hood
Have also attached an iges of the board, just have to make sure you make it the right way round
Presume thats H-4050 motors? They should work 1:1 but you may need to get some active shunts for the drives. I think the 009 drives are micro drives so no shunt circuitry in them. I have 020 drives and I still needed the active shunts to get the best accel I could, see pic.
Hood