14731
General Mach Discussion / Re: Somethings missing......?
« on: September 15, 2010, 02:28:09 AM »
You have Enable and Z Dir as the same pin, also you have pin 6 used for X Dir and MPG1 (MPG is an Input) and you are also sharing Pin 15 for MPG1 and MPG2, they all need to be different. You also have Port 6 for MPG1 B channel, needs to be set to Port1
Is the port address correct, if using the on board port it is likely to be correct but check in device manager to make sure.
Hood
Is the port address correct, if using the on board port it is likely to be correct but check in device manager to make sure.
Hood