19701
General Mach Discussion / Re: Spindle Direction
« on: March 30, 2009, 02:01:11 PM »
Its been a long long time since I looked at Mach2 and I forgot how antiquated it was
I dont see a problem so far with the possible exception that you have the active low for Step on spindle and A axis set to opposites. Not sure how that would cause a problem but may be worth making them the same just to see.
I will try and navigate my way through the rest of the settings and see if I can find anything else.
Hood
I dont see a problem so far with the possible exception that you have the active low for Step on spindle and A axis set to opposites. Not sure how that would cause a problem but may be worth making them the same just to see.
I will try and navigate my way through the rest of the settings and see if I can find anything else.
Hood