2731
General Mach Discussion / Re: No -X movment from GCode in Router Table
« on: April 14, 2014, 04:46:05 PM »
So you can jog the X both positive and negative directions but running code it will only move the X in a negative direction?
Not sure what you mean by "and the DROs reset, " Can you try and be a bit cleaer on what you mean.
If you can also attach the code you are running .
Just to be clear when you mention -X, are you meaning X DRO values going negative or just the axis running in a negative direction, ie may still be positive values in the DRO but wont move so as values decrease?
Hood
Not sure what you mean by "and the DROs reset, " Can you try and be a bit cleaer on what you mean.
If you can also attach the code you are running .
Just to be clear when you mention -X, are you meaning X DRO values going negative or just the axis running in a negative direction, ie may still be positive values in the DRO but wont move so as values decrease?
Hood