8131
General Mach Discussion / Re: Spindle won't run with MDI or G-code
« on: July 16, 2012, 02:02:13 PM »
Ok sorry I saw you said you were using the ESS, should read more carfully.
Ok I dont have a spare ESS so cant look at your ESS config but make sure you have the spindle set for Step/Dir in it (I assume thats what you are using anyway)
If that is not the problem check in the macro folder for your profile and see if the M3 macro is there and that it has DoSpinCW() in it.
Hood
Ok I dont have a spare ESS so cant look at your ESS config but make sure you have the spindle set for Step/Dir in it (I assume thats what you are using anyway)
If that is not the problem check in the macro folder for your profile and see if the M3 macro is there and that it has DoSpinCW() in it.
Hood