19261
General Mach Discussion / Re: Turn G3 feedrate problem
« on: May 09, 2009, 11:42:36 AM »
can you attach your xml as well please
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
The problem with swap axis . . as has also been said before . . . is that once you go into 'spindle mode' you loose all reference to azimuth.
If there is some way to get that back, within code or simple macro, no one has yet posted it that I have seen.
The comment on motor speed is simply inaccurate.In what way?