12331
General Mach Discussion / Re: Troubleshooting Limits
« on: March 08, 2011, 07:44:58 AM »
That is because you let Mach fix it and it set the active state of the limits and E-Stop to active Low, change them back to the way they were.
Which end of the cable did you disconnect? If the computer end then it would seem your parallel port is bad. To test change the port number for port 1 to 0278 and port 2 to 0378 and see what happens
Hood
Which end of the cable did you disconnect? If the computer end then it would seem your parallel port is bad. To test change the port number for port 1 to 0278 and port 2 to 0378 and see what happens
Hood