10681
General Mach Discussion / Re: Index Pulse Setup Problems (Lathe)
« on: September 13, 2011, 04:35:17 PM »
I know that threading can not be done in Demo so possibly index pulse will not either although I think it does.
Index Debounce has always been fine for me at 0 and never any good at anything else.
If you attach your xml I will have a look and see if there are probs in it.
Hood
Index Debounce has always been fine for me at 0 and never any good at anything else.
If you attach your xml I will have a look and see if there are probs in it.
Hood