18831
General Mach Discussion / Re: Mouseless operation of Mach 3 using programmable POS keyboard
« on: June 17, 2009, 12:56:40 AM »
That is the problem with using HotKeys, you need the button that it is working on the page you are viewing. If you can use the keyboard buttons as digiotal inputs then you could set each key up as an oem trigger and that way it would not require a button on screen to operate.
Failing that you can open the screenset in Screen4 making sure your monitor is at a higher resolution than the screenset and place the buttons out of the normal screen area. This will only work if you are not using Auto Screen Enlarge in General Config.
Another way would be to use image buttons but dont asign an image, you will see them in Screen4 but not in Mach.
Hood
Failing that you can open the screenset in Screen4 making sure your monitor is at a higher resolution than the screenset and place the buttons out of the normal screen area. This will only work if you are not using Auto Screen Enlarge in General Config.
Another way would be to use image buttons but dont asign an image, you will see them in Screen4 but not in Mach.
Hood