2151
General Mach Discussion / Re: Go To Zero Problem! Please to help me!
« on: November 14, 2014, 01:44:57 PM »
You can write a macro and place it in your macro folder for the profile you are using. Call it something like m123.m1s (custom macros should be greater than 100) and then if you place m123 at the end of your code it will do what is in the macro.
To do what you want the macro would simply contain
Code"G0X0Y0"
The above is for work offset zero, if it is machine coords zero then
Code"G53G0X0Y0"
hOOD
To do what you want the macro would simply contain
Code"G0X0Y0"
The above is for work offset zero, if it is machine coords zero then
Code"G53G0X0Y0"
hOOD