761
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: May 24, 2016, 05:54:43 AM »
Ok if you have it set up for -10 0 +10v command then that is correct.
Not sure why it is stopping outputting to the DROs in Mach but as it is showing whilst Mach is in reset then it may be that the IP-A is not configured correctly.
If you attach your xml I can have a quick look.
Hood
Not sure why it is stopping outputting to the DROs in Mach but as it is showing whilst Mach is in reset then it may be that the IP-A is not configured correctly.
If you attach your xml I can have a quick look.
Hood