Dave,
sorry no vid yet as there are a few issues
Ron
Either I am misunderstanding or its wrong, I thought the safe position on Tool page would be for the toolchange to happen but it actually does the change first then moves to that position which is not good.
Also on Boring page and possibly others if you enter negative values (I am using the front post for boring thus neg values as rear is default turret with pos X values) then say you want to bore from 25mm out to 30 I would enter X Start as -25 and X End as -30 but the wizard sees this as an error stating X Start (actually says Xatart) can not be greater than X End. I can see why it would think that but its wrong
Hood