8141
General Mach Discussion / Re: Inputs not working
« on: July 15, 2012, 11:40:31 AM »
You do not have any inputs enabled except the E-Stop.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
You may need 3 axis' to run at once so that will increase the need by 3.Unless the centipede is different from Machs Parallel Port driver then the amount of axis does not mean you need a higher kernel, the frequency is per axis so for example if you required 100KHz on an axis you coulld run all axis at 100KHz.