18281
General Mach Discussion / Re: oem code for tooloffset number (turn)
« on: August 16, 2009, 06:36:20 AM »
There isnt one and is one of the things that hopefully will be added in the new revision of MachTurn.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
If you unplugged the cables from a previously bad drive and plugged them into the good drive and that axis started behaving then it can only be a drive fault I would say.
Hood
I actually missed that little fact, sorry- I'll go back to my corner now-
Dave
I'm, sorry, but I don't know what you mean... "double iso" (duh)