Messages

491

General Mach Discussion / Re: setting up mach3 for the first time - driver test "no driver sensed installed"

« on: March 06, 2021, 01:55:23 AM »

you have two possibilities:

1st Change motor wiring

A+ yellow
A- blue
B+ red
B- green

2nd invert the Setting for dir pin (active Low) of slave axis 

492

CS-Lab / Re: ePID fault... press RESET Mach 3 CSMIO/IP-A

« on: March 05, 2021, 10:29:45 AM »

did they install a new Version of Mach3?

493

General Mach Discussion / Re: How to chnage parameters for HOME position on LEFT sides of X Axis.?

« on: March 05, 2021, 10:28:11 AM »

Show us your G-Code file.

494

General Mach Discussion / Re: Z axis is lifting higher and higher after each cut

« on: March 05, 2021, 10:25:08 AM »

G00 Z10.0000
X11.6124 Y15.7764
G31 Z-150 F300.0
G92 Z-3.4000 (3.4 mm off-set until sensor triggered)
G00 Z3.0000
M30

put just this code in a G-code file and run it multiple times, then check z-axis dro and physical z-Position.

495

General Mach Discussion / Re: Z axis is lifting higher and higher after each cut

« on: March 05, 2021, 06:09:55 AM »

can you pls post code how the zeroing is done? then we will have a look.

496

General Mach Discussion / Re: Mach3, Opt Laser 5W and Aspire

« on: March 05, 2021, 01:11:23 AM »

Looks like this solution would work.

497

General Mach Discussion / Re: Will mach 3 control a K40 laser?

« on: March 04, 2021, 06:39:50 AM »

there is a Software called K40 Whisperer.
witch might be suitable, just a thought.

498

Show"N"Tell ( Your Machines) / Re: LMS 5500 (SX2.7) Conversion

« on: March 04, 2021, 03:30:48 AM »

to use an external micrcontroller is also a plan, but 57CNC board can provide a 0-5V Signal and has a lot Outputs witch
can be used to "emulate" the pushbuttons.

499

General Mach Discussion / Re: setting up mach3 for the first time - driver test "no driver sensed installed"

« on: March 04, 2021, 03:10:32 AM »

this document:

https://www.buildyourcnc.com/Documents/PN.SM86HT80-5504B-U(inhouse%20PN.85BYGH450A-47-80)%20(1).pdf

says Motor Connections should be:
A+ red
A- green
B+ yellow
B- blue

different to your wiring.

sorry in interpreted the 20,000 as 20000 and not as 20, because 20000 would be extremly to much.
i have chosen 400 because your Motor is a 1.8Deg Motor so we have 200Steps/rev.
stepper controler is set 1/2 step so 200*2=400.

500

VB and the development of wizards / Re: autotoolzero

« on: March 04, 2021, 02:59:05 AM »

there are a few possibilities for the failue:

-wiring
-electric noise on your wiring
-defective BOB