Messages

1591

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: November 22, 2018, 01:30:53 AM »

attached a principal sheme for a Hardware circuit to do the squaring via relay/optocoupler.



@Craig
i absolutly aggre with you according XHC

1592

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: November 21, 2018, 02:49:03 PM »

....Chinese made stuff is rip-off junk.
Craig

i not agree 100%, some stuff (you have to find it) is not so bad.
i have a chinese servo Motor supplier witch deliveres realy good things for a very nice Price. 

1593

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: November 21, 2018, 04:01:06 AM »

ok after a while of googling, it seams to be a XHC Problem.

have a look here:

https://www.cnczone.com/forums/mach-software-artsoft-software-/334846-mach3-xhc-machmotion-ethernet-card-slave-axis.html

simular Problem.

1594

VB and the development of wizards / Re: VB - vbNullChar pass to function

« on: November 21, 2018, 03:58:36 AM »

ok, i have no Experience about modbus,
maybe i can help a Little bit with VB Scripting.

1595

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: November 20, 2018, 02:34:23 PM »

do you use PP or a Controller?

1596

General Mach Discussion / Re: Plasma on Mach3 - Randomly Cutting Imperfect Circles

« on: November 20, 2018, 02:31:24 PM »

pretty simple

use the MDI

-put your x axis to the left end
-zerro x axis
-mark this startpoint somewhere physicaly
-take real Speed F100 (don't know in witch Units (imperial/metric) you are working)
-then G1 X? (? should be something at the right end of your machine)
-then G1X0
-then G1 X? ?(should be something at the right end of your machine)
-then G1X0

... and so on about 10-20 times
-wath your physicaly mark for X0

and then the same for y axis

1597

VB and the development of wizards / Re: VB - vbNullChar pass to function

« on: November 20, 2018, 02:23:59 PM »

hello Robert,

can you pls describe, what you realy want to do.

for the Moment i am not able (maybe to old for this) to follow/get the real challenge.

1598

VB and the development of wizards / Re: VB - vbNullChar pass to function

« on: November 20, 2018, 02:25:13 AM »

and a third one, seems to be ok.

1599

VB and the development of wizards / Re: VB - vbNullChar pass to function

« on: November 20, 2018, 02:22:48 AM »

Hi Robert,

did two test's, see screenshots.

1600

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: November 20, 2018, 02:03:12 AM »

home slave with master axis enabled?