Hello Guest it is March 29, 2024, 10:31:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TPS

1211
General Mach Discussion / Re: My stepcraft DL445 laser leaves a path
« on: June 14, 2019, 02:55:38 PM »
OK, one eye is a Little bit sad to hear, that you gave up, but only one eye. ;) ;)

1212
General Mach Discussion / Re: My stepcraft DL445 laser leaves a path
« on: June 14, 2019, 09:25:47 AM »
got some more documentation about Pins of laser Interface.

and sorry, i was wrong in an earlier reply M11P1 means Switch Output 1 ON

1213
General Mach Discussion / Re: My stepcraft DL445 laser leaves a path
« on: June 14, 2019, 09:14:31 AM »
next try.

1214
General Mach Discussion / Re: My stepcraft DL445 laser leaves a path
« on: June 13, 2019, 11:59:02 PM »
i will try to contact stepcraft to get more information

1215
or use a tranparent button

1216
General Mach Discussion / Re: My stepcraft DL445 laser leaves a path
« on: June 13, 2019, 02:03:59 PM »
well, walked through the stepcraft Manual, not getting 100% clever, but here a "try"

pls try also Output1 Active Low Setting.

1217
General Mach Discussion / Re: My stepcraft DL445 laser leaves a path
« on: June 13, 2019, 12:51:35 PM »
sorry missed that you posted your Profile.

you are Controlling your laser via Spindle Motor control step Signal (chankspindle/chankspindleoutput).

output1 is assigned to pin0 (chankoutputs), so M10P1/M11P1 can not work (should be pin17)


1218
General Mach Discussion / Re: My stepcraft DL445 laser leaves a path
« on: June 13, 2019, 12:36:52 PM »
never used it, but M10P1 means Switch Output 1 ON, and to what (ports&pins) is your Output#1 assigned.

for the Moment you use M3/M5 to turn laser ON/OFF?

what is your output configuration Config -> Ports&Pins -> Spindle Setup -> Relay Control ?

are you using are original UC100 or a chinese clone?

1219
General Mach Discussion / Re: too slow for pulley using min
« on: June 13, 2019, 12:21:21 PM »
for radius Problem goto Config -> General Config and make Setting correspondig to post processor

1220
General Mach Discussion / Re: too slow for pulley using min
« on: June 13, 2019, 12:18:39 PM »
goto Settings and check witch pulley is selected

goto Config -> Spindle Pulleys and check Min value of selected pulley