Messages

1961

General Mach Discussion / Re: Limit switch set up on Mach3 with the Gecko g540

« on: March 08, 2018, 02:54:41 PM »

question:
for what do you realy Need charge pump ?

sorry i did not get this !?

btw. the XML Looks ok now for e-stop.

Thomas

1962

General Mach Discussion / Re: Limit switch set up on Mach3 with the Gecko g540

« on: March 08, 2018, 11:13:39 AM »

also your just sended XML says that e-stop emulated is checked.

in worst case i would Setup an new blank Profile.

1963

General Mach Discussion / Re: Limit switch set up on Mach3 with the Gecko g540

« on: March 08, 2018, 11:12:19 AM »

I am not seeing any change with the indicator you circled... It stays yellow regardless of switch being open or closed.

there is something wrong, it should Change Status.

1964

General Mach Discussion / Re: Limit switch set up on Mach3 with the Gecko g540

« on: March 08, 2018, 10:39:46 AM »

can you please post your XML again?

you said Emulated is unchecked, the XML you posted earlier says emulated is checked.

if your e-stop Switch is connected to pin15 the led in UC Monitor shouls Change if you Switch it.
 

1965

General Mach Discussion / Re: Limit switch set up on Mach3 with the Gecko g540

« on: March 08, 2018, 10:17:04 AM »

can you see input15 changing if you push the button in the uc100 i/out Monitor?

1966

General Mach Discussion / Re: Limit switch set up on Mach3 with the Gecko g540

« on: March 08, 2018, 10:07:43 AM »

do you have a "real" e-stop button ?

1967

General Mach Discussion / Re: Limit switch set up on Mach3 with the Gecko g540

« on: March 08, 2018, 10:03:25 AM »

had a quick look to your XML, you posted.

there is the e-stop is emulated enabled.

is your e-stop realy emulated ?

1968

General Mach Discussion / Re: Limit switch set up on Mach3 with the Gecko g540

« on: March 08, 2018, 09:51:21 AM »

i have realy no experience with the UC100,
but the red idle led would make me thinking about.

whats about to contact Automation Technology Support
to get a information what the red idle led want's to tell us.

in the manual i found nothing about red only about green ight.

1969

General Mach Discussion / Re: anilam 3000 retro fit?

« on: March 03, 2018, 12:18:43 PM »

i think a:

CSMIO/IP-A

is not a bad choice.

but let's see what else is comming up.

1970

General Mach Discussion / Re: Limit switch set up on Mach3 with the Gecko g540

« on: March 03, 2018, 12:13:12 PM »

I'm sorry, I do not understand what the XML is that I should post. I will surely do this if it is explained.
Tony

c:\Mach3\Your profilename.xml