2421
VB and the development of wizards / Re: macro for homing
« on: February 07, 2015, 03:15:35 AM »
hello,
have a look for oembutton(150).
Thomas
have a look for oembutton(150).
Thomas
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Where can I get CSMIO/IP Motion Montroller Configuration tool?
But I'm still curious to know why STEP/DIR output minus signals (e.g. pins 14 and 15) do not fuction as expected.
How is it, are these IOs protected e.g. against short circuit or not?yes only step/dir not.
Are the signals fixed or can these be configured in Mach like it is the case with LPT-port?in Mach3 port/pin -> motor outputs only the enable axis is important rest is done in the
just cannot get the meaning of "and in the CSMIO/IP-M we have to use the GND on 2nd PIN or ANALOG I/O 8 connector"
Where the GND can be found from, is it analog IO terminal pin #2 or pin#8 or what?