Hello Guest it is March 01, 2021, 12:07:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TPS

981
General Mach Discussion / Re: LATHE SPINDLE
« on: January 18, 2019, 02:29:32 AM »
attached a part of the Manual for the wiring,
you can select the mode via paramater.

982
General Mach Discussion / Re: Code for Belleville-Sprung Tool Change
« on: January 18, 2019, 02:20:06 AM »
in normal Operation you can move with a

G53Y??

to machine coords you whant, homing Switch does not matter, only Limit Switches (Z++ Z--) will
be active.

983
ok i think you have something simular to this:

https://www.ebay.com/itm/4Axis-Nema23-stepper-motor-425oz-DUAL-SHAFT-Driver-DM542A-CNC-Longs-Motor-/200998727736

this set has a parallel port breakout board.

for pp you have to have a pc with win7 32bit, and a real parallel port.

usb to pp will not work, does not matter witch win Version you have.

if you want to use win10/64bit you have to go to a external Motion Controller.

like uc100, smoothstepper ore something lik this.


oops Bryanna was faster  ;)

985
I do use A TC-50M as a controller.

ok had a look to the Manual, in this case i think 0 for step/dir pules is ok/does not matter.

back to the Basic Problem.

did you check the real distances as described (MDI G1Xsomething) and measure ?
same for Y axis.

anyway, if the real distances match to to the DRO's, X and Y should move the same Speed.

you can also do a simple test via MDI

G1X300Y300

should give a simulitanious move of both axis.



by rereading all the post's i recogiced that your machine is belt driven (my bad english,and the Age).

ok that means one motorrevolution is 40mm, right?

in this case your motortuning of velocity 400mm/min is very low (what actually means for the Motor 10 rev/Min).

don't realy know what Speed you expected to run?, but i think for a woodmill (have no Experience with Wood),
it is IMHO to slow.



 









986
ok from motortuning X an Y should run the same Speed.

i would put 40 for acceleration.

a bit surprises me that step pulse and dir pulse is Zero, put 5 in there.

are you using parallel port or a Motion Controller ?

987
can you please post a screenshot of

Config->Motor Tuning -> X-axis and
Config->Motor Tuning -> Y-axis


my pulley is a 20 teeth and the second wheel ? how many teeth?

988
you can do simple test of your calibration.

- jog your X-axis to the left (minus) side
- Zero x-axis
- put a mark somewhere to measure afterwards
- put F300 into MDI
- put G1X300 into MDI
- measure the distance


the toolpath Display is an other part, important is that your values in the axis dro's
are equal to the real movement.


989
General Mach Discussion / Re: New Mach 3 Won't load G code
« on: January 14, 2019, 02:23:12 AM »
can you post oene the .crv files witch does not work ?

990
Mach3 under Vista / Re: USB to PARALLEL WIN 7
« on: January 11, 2019, 03:16:19 PM »
Is it possible to use a usb to parallel cable converter on a K2 cnc with geckos.. Is there a special setup???
just in case I need to upgrade to a newer computer

just NO