Messages

141

General Mach Discussion / Re: Z Axis - moves past home switch and does not back off

« on: April 02, 2023, 10:01:27 AM »

ok,then it is a simple PP breakout board, no motion controller.

you are using Ref. Z button on diagnostic page to start the test
the z-axis seperate?
home, homing and reference are a little mixed up terms in Mach.

142

General Mach Discussion / Re: Mach3 is tool z lifts when running code. Tool does not touch work.

« on: April 01, 2023, 02:36:17 AM »

pls post your G-code

143

General Mach Discussion / Re: Z Axis - moves past home switch and does not back off

« on: March 31, 2023, 11:39:25 AM »

tryed to find a manual for CNC4YOU KK10 control board, no luck, is it a KK01 probably?

144

General Mach Discussion / Re: Mach3 is tool z lifts when running code. Tool does not touch work.

« on: March 30, 2023, 10:04:15 AM »

open Config -> Fixtures an have look what offset's are in there for G54

145

General Mach Discussion / Re: Z Axis - moves past home switch and does not back off

« on: March 30, 2023, 03:21:40 AM »

individual inputs would be the better choice, if you have enough free inputs.

146

General Mach Discussion / Re: Z Axis - moves past home switch and does not back off

« on: March 30, 2023, 02:34:11 AM »

check in diagnostic screen for M3home LED

147

General Mach Discussion / Re: Mach3 is tool z lifts when running code. Tool does not touch work.

« on: March 30, 2023, 02:30:58 AM »

maybe your code uses a work piece offset G54 ..
or a M6 is included and it activates tool length offset.

without seeing the G-code it is hard to say.

148

Machscreen Screen Designer / Re: Show image based on condition / tool magazine visualization

« on: March 28, 2023, 06:22:28 AM »

the only way i can imagine might be:
-insert in screen a picture for each TC place ( TCplace1.png to TCplacexx.png)
-create images for each tooltype empty.png,drill.png,endmill.png ...
-copy with a VB script condition based for example drill.png -> TCplace1.png
-reload screen sheet

not tested, just an idea.

149

General Mach Discussion / Re: Runaway Jog Mach 3

« on: March 28, 2023, 05:38:25 AM »

ok, rnrmotion.dll is a plugin for a chinese (and many clones) usb controller, witch
is known to make trouble. you can try to find a newer version of the plugin and
see if it helps. 

150

General Mach Discussion / Re: 2 Different auto zeros

« on: March 28, 2023, 05:31:15 AM »

you will need to use two different screenset's