Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TPS

1
General Mach Discussion / Re: simple macro not working,
« on: February 21, 2019, 01:15:50 AM »
ok i have tested here, and you are right.
for what ever reason M100 does not work, try M101.M1S

2
General Mach Discussion / Re: simple macro not working,
« on: February 20, 2019, 12:41:25 PM »
but it is in the right Folder?

C:\Mach3\macros\your profilename

any errormessage in the status line?

3
General Mach Discussion / Re: simple macro not working,
« on: February 20, 2019, 01:34:22 AM »
try this:

Code: [Select]
code "g91"
code "g0 z-.0001"
While IsMoving()
Wend
code "g90" 


4
General Mach Discussion / Re: Spindle relay on by M3 command
« on: February 20, 2019, 01:31:46 AM »
ok found some additional Information, where it Looks like relay Output is port1 pin1.

so check:
->Config -> Ports & Pins -> Spindle Setup
    -disable spindle relays is not selected
    -ClockWise (M3) Output# is 2

->Config -> Ports & Pins -> Output Signals
   -Output #2 is enabled
   -Output #2 port is 1
   -Output #2 pin number is 1

5
General Mach Discussion / Re: Spindle relay on by M3 command
« on: February 19, 2019, 09:08:26 AM »
any documentation about this board?

6
General Mach Discussion / Re: MACH 3
« on: February 17, 2019, 03:14:01 AM »
according to your Diagramm X and Y are swapped.


     Y+
X- -|- X+
     Y-

thats how your tool should move on the surface.

7
General Mach Discussion / Re: Pierce delay for plasma cutters.
« on: February 16, 2019, 05:40:26 AM »
have a look for:

Config -> General Config -> General Configuration -> G04 Dwell in ms

8
Mach4 General Discussion / Re: hybrid servo motor, Pockeys57cnc and mach4
« on: February 15, 2019, 07:41:06 AM »
Hello Jonathan,

i will answere here, because other thread is not the right place i think.
i am afraid not to be a great help, because i have no experince in Mach4.
have you worked through all step's of the Manual witch start on page 30?

maybe one of the Mach4 guru's can jump in here.

Tom

10
General Mach Discussion / Re: mach3 and Bridgeport Boss5
« on: February 14, 2019, 03:04:47 PM »
backslash?