1261
General Mach Discussion / Re: Rotary spindle encoder setup
« on: May 23, 2019, 07:21:16 AM »
found some german documantation witch says Encoder index pulse is connected to pin15.
but no Information wether port1 or port2.
you can try and error, just set up ports/Pins -> Inputs -> Index to pin15 and
when you turn spindle by Hand you should see something in diagnostic Screen from turn screenset.
but no Information wether port1 or port2.
you can try and error, just set up ports/Pins -> Inputs -> Index to pin15 and
when you turn spindle by Hand you should see something in diagnostic Screen from turn screenset.